Stonethane
Concrete and Stone Finish (268FF)

Features | Properties | General Directions

Application Hints | Pad Recommendations | FAQ

Packaging Specifications | MSDS

Features

• Tough urethane seal/finish for use on all stone and concrete floors.
• Urethane formula protects stone and concrete floors from wear and simplifies maintenance.
• Excellent chemical resistance.
• Responds to high-speed buffing.
• Use on concrete, terrazzo, quarry, paver brick, unglazed ceramic, slate and resilient tile floors.

Properties*

• Type - Urethane/Acrylic Emulsion
• Form - Opaque Liquid
• Odor - Bland
• Color - Milky White
• Weight Per Gallon - 8.58 Lbs.
• pH - 8.4 - 8.9
• Floor Solids - 17%
• Coverage - Up to 2,000 Sq. Ft. Per Gallon (50 m² per liter)
• Dry Time - 30 to 45 Minutes
• Slip-Resistance - UL Classified
• V.O.C. Content - < 375 gm/l
  

* Properties are typical and subject to usual manufacturing tolerances.

General Directions**

Application:

1. Strip floors to remove old waxes, sealers and finishes.
2. Rinse thoroughly and let dry.
3. With clean equipment apply thin, even coats of Stonethane.
4. Under normal conditions, allow to dry for 30 to 45 minutes between coats.
5. For best results, apply a maximum of 4 coats in 24 hours.
   Note: Where floors have been acid crystallized, scrub at least once with a mild alkaline detergent. Do not use high alkaline strippers on marble and terrazzo floors.

Maintenance:
Daily:

1. Sweep or dust mop as necessary to remove gritty soil.
2. Use our neutral cleaner to damp mop spills as they occur. Damp mop or auto-scrub nightly with Nu-Tral Cleaner (#507).
3. Buff if desired with high speed equipment and ultra high speed pads.

Weekly:

1. To repair and deep clean floor, apply our Citrus Scrub 'N Shine (#525) with mop or auto-scrubber.
2. Allow floor to dry.
3. Burnish floor with high speed equipment. This finish also responds to spray buffing with conventional speed equipment.
   Note: Always dust mop after burnishing or spray buffing.

Periodic Recoating:

1. Dust mop entire floor then scrub aggressively using our Citrus Scrub 'N Shine and auto-scrubber with a red or green pad.
2. Use a blue pad for heavily marked or unusually dirty floor.
3. Rinse floor and allow to dry.
4. Apply one or two coats of Stonethane.
   

** See label directions and MSDS for complete usage and safety instructions.

Application Hints

1. Stonethane is very easy to apply with a standard finish mop and dries perfectly clear.
2. Use of a seal is recommended on concrete or porous floors.

Pad Recommendations *

Packaging Specifications

Package	Sizes Available	UPC Codes	Pack Size (inches)	Cube (ft.)	Pack Wt. (Lbs.)	Full Pallet
	55 Gallon Drum	783366268009	23 x 34	10.41	492.78	4
	5 Gallon Pail	783366268054	12 x 14	1.17	45.98	36