Directions

1. APPLICATION:
   Strip floors to remove old waxes, sealers and finishes.
   Rinse thoroughly and let dry.
   With clean equipment apply thin, even coats of finish.
   Under normal conditions, allow to dry for 30 minutes between coats.
   For best results, apply a maximum of 4 coats in 24 hours.

   NOTE: For stripping and maintaining asbestos containing tile, follow OSHA guidelines or EPA guidelines.

2. COVERAGE: One gallon covers up to 3,000 square feet (1 liter covers 75 m2).
3. MAINTENANCE:Daily:
   Sweep or dust mop as necessary to remove gritty soil.

   Dirty Floors:

   Clean with 2-4 oz. of neutral floor cleaner per gallon of water (16-32 ml per liter). Rinse and let dry.

   Traffic Area:

   Clean with 2-4 oz. of neutral floor cleaner per gallon (16-32 ml per liter) of water. Rinse and let dry. Apply additional thin coats of floor finish to traffic lanes as needed.

   Buffing:

   If desired, periodic burnishing with blended hair pads will enhance appearance.

   Periodic Complete Maintenance:

   Ordinarily, stripping is not required more than (1) or (2) times per year. Use up to 32 oz. of our stripper per gallon (256 ml per liter) of water.

See label directions and SDS for complete usage and safety instructions.