Directions

Application:

1. Strip floors to remove old waxes, sealers and finishes.
2. Rinse thoroughly and let dry.
3. With a clean rayon mop apply thin, even coats of Eccothane.
4. Under normal conditions, allow to dry for 30 minutes between coats.
5. For best results, apply a maximum of 4 coats in 24 hours.

Maintenance:
Daily:

1. Sweep or dust mop frequently to remove gritty soil.
2. Use our Nu-Tral Cleaner(507FC) to damp mop spills as they occur. Damp mop or auto-scrub nightly with Nu-Tral Cleaner(507FC).
3. Buff if desired with high speed equipment and soft ultra high speed pads.

Weekly:

1. To repair and deep clean floor, apply Citrus Scrub ‘N Shine(525FR) with mop or auto-scrubber.
2. Allow floor to dry.
3. Burnish floor with high speed equipment. This finish also responds to spray buffing with conventional speed equipment. Note: Always dust mop after burnishing or spray buffing.

Periodic Recoating:

1. Dust mop entire floor then scrub aggressively using Citrus Scrub ‘N Shine(525RF) and auto-scrubber with a red or green pad.
2. Use a blue pad for heavily marked or unusually dirty floor.
3. Rinse floor and allow to dry.
4. Apply one or two coats of Eccothane.

See label directions and SDS for complete usage and safety instructions.

WARNING: Reproductive Harm – www.P65Warnings.ca.gov.