Application

Before use, read “Preparation.”

ALWAYS TEST each surface for suitability and results before overall application. Use the following application instructions. Let surface dry thoroughly before inspection.

Dilution & Mixing: Apply as packaged. Do not dilute or alter, or use other than as specified. Mix well before use.

Typical Coverage Rates: Variations in surface texture, concrete quality, porosity, job-site conditions, temperature and relative humidity affect coverage and drying. The following figures are for estimating only.

Estimated Coverage Rates

• 1500-2000 square feet per Gallon
• 135-185 square meters per Liter

Application Instructions
The product may be applied to broomed, steel troweled, honed, polished or highly polished interior concrete surfaces.

1. Lightly wet a clean microfiber pad with Imperium, leaving the pad damp.
2. Spray-apply or use a pour can, Imperium can be applied to surface in a bead and spread with a flat mop. Work from one control joint to another.
3. Spread with the damp microfiber pad. Maintain a thin, even coating and wet edge. Stop spreading once drying begins. Do not overlap.
4. Allow to dry tack free, typically 15-30 minutes.
5. Before applying the next coat, burnish with a propane machine equipped with a 6000 – 10,000 grit diamond pad.
6. Repeat steps 1-4. Two coats are recommended for maximum protection and shine.
7. To increase gloss, use a high-speed burnisher and 6000 – 10,000 grit diamond pad.
8. For maximum gloss, continue burnishing with a white polishing pad. Burnish at a fast walking pace.

Protect from water for 4 hours.

The product gains its full stain repellency properties in 7 days.

Cleanup: before the product dries, clean tools and equipment with fresh water. Immediately wash over spray off glass, aluminum, polished or other surfaces with fresh water.

Read label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand.