Directions

NOTE: Always pretest the cleaner on the carpet in an inconspicuous area before use.
For Use as a Spotter:

1. Use product at full strength.
2. Soak or scrape up as much of the spill as possible. Start at edges of the spot and work toward the center, dabbing gently. DO NOT RUB.
3. Spray a small amount of En-Case directly on the spot and remove the loosened dirt with a clean, white towel, using a blotting action. Do not over wet the area as this will spread the spot.
4. Repeat steps 2-3 until the spot is gone.
5. If spot reappears after drying, repeat the process.

Extraction:

1. Vacuum work area thoroughly.
2. Pretreat traffic lanes and spots.
3. Dilute 1 oz. (1:128) of En-Case per gallon of water.
4. Extract work area.

Bonnet:

1. Vacuum work area thoroughly.
2. Pretreat traffic lanes and spots.
3. Dilute 4 oz. (1:32) of En-Case per gallon of water.
4. Prespray dry bonnets before use.
5. Spray solution on a 10’ x 10’ area and buff carpet clean.
6. Repeat step 5 on another 10’ x 10’ area.

See label directions and SDS for complete usage and safety instructions.