|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Products
| Equipment | Product
Systems | Technical Help Training Aids | Sales Support |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
40%
Gym Finish
|
 |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
* Properties are typical and subject to usual manufacturing tolerances.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Recoating:
For wooden floors that have been previously finished, clean away
water-soluble soil by damp mopping or wet scrubbing and allow to dry.
Do not allow water to penetrate into wood floors. Care must be taken not
to warp floor. For best inter-coat adhesion, abrade floor to remove black
marks. Apply a waterless cleaner onto floor with wet mop 3-5 minutes ahead
of stripping, using the rotary floor machine and black wax stripping pad
or screen disc. Move machine at the pace of a slow walk in full head passes
overlapping 1-2 inches. Tack rag with waterless cleaner to remove dust
particles. To increase efficiency of tack rag process, use an E-Z Way™
Applicator to continuously feed cleaner to tack rag. Finish may be applied
with E-Z Way, lambs' wool, or spray.
For Using E-Z Way™ Applicator:
Freshly Sanded or Fully Stripped Floors: If chemically stripped, scrub with a waterless cleaner to remove stripper residue. Pick up solution with wet-dry vac or mop. Screen with No.100 Grit Adhesive Screen to smooth raised grain of wood. Tack rag and apply one coat of finish. When dry, screen again with 100 Grit Adhesive Screen and tack rag. Apply court lines, if desired. When dry, screen lines lightly with 120 Grit and apply a minimum of two additional coats of finish. Coverage and Dry Time: Approximately 500 sq. ft. per gallon, depending on floor texture and porosity. Can be recoated when dry, approximately 5-10 hours, depending on humidity and temperature. If recoating after 24 hours, burnish between coats. Floor can be open to normal traffic in 24 hours. Athletic sports floors: 72 hours to 7 days for extra hard use. ** See label directions and MSDS for complete usage and safety instructions.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
