|
Step
1: Assemble Supplies and Safety Equipment
| Low Speed Machine |
| Nylo-Grit® Brush |
| Clean Mop |
| Mop Bucket |
| "Wet Floor" Signs |
| Rubber Boots |
| Gloves |
| Safety Glasses |
| Grout Avenger™ (#299RR) |
| Deck Brush |
| Floor Squeegee and/or Wet Vac |
| Broom and Dustpan |
| Fan |
Step
2: Sweep Area
Sweep area and remove any large debris.
Step
3: Dilute Chemicals
Mix Grout Avenger™ (#299RR) 1:4 (32 ounces per gallon) with water in a mop bucket.
Step 4: Wet Floor Signs
Place "wet floor" signs at any entrances to work area
Step 5: Apply Cleaning Solution
Liberally apply cleaning solution to floor using a mop. Allow product to dwell for 10-15 minutes before scrubbing. If you are cleaning a large area, break it up into sections to prevent grout resoiling or floor drying.
Step 6: Scrub Floor
Using a low speed machine and a Nylo-Grit® brush, thoroughly scrub the floor.
Step 7: Remove Cleaning Solution
Force cleaning solution into floor drain with a squeegee. You may need to apply clean water to accomplish this. If there is no floor drain, or if it is not functioning properly, remove cleaning solution with a wet-vac. Place fan to speed drying process.
Note: Test a small area before attempting this process. If grout does not release soil, it is likely sealed. Note: Grout dries slowly. Allow 8-10 hours after procedure before reopening the area. |
