G2 Green Finish
High Performance Floor Coating (8201FF)

Features | Properties | General Directions

Application Hints | Pad Recommendations | FAQ

Packaging Specifications | MSDS | Flyer | Literature Sheet

Green Seal Certification

Features

• Non-yellowing, low-maintenance formula offers industry-leading black mark and scuff resistance.
• Applies easily, levels nicely and dries to a deep gloss.
• Zinc-free, APEO-free and phthalate-free finish.
• Low emission formula – meets new 1% VOC Regulation.
• Ammonia-free, low odor.
• Combination seal and finish.
• Fast-drying – 20 minutes under normal conditions.
• Large area coverage – up to 3,000 sq. ft. per gallon.
• Green Seal GS-40 certified.
• Also Green Seal Certified in 16% and 18% solids.

Properties*

• Type - Acrylic Emulsion
• Form - Opaque Liquid
• Odor - Bland
• Color - Milky White
  
• Film Clarity - Clear
• Weight Per Gallon - 8.61 Lbs.
• pH - 7.1
• Floor Solids - 20%
  
• Storage Stability - Minimum 1 Year
• Freeze/Thaw - Do Not Freeze
• Slip Resistance - UL Classified

* Properties are typical and subject to usual manufacturing tolerances.

General Directions**

Application:

1. Strip floors to remove old waxes, sealers and finishes.
2. Rinse thoroughly and let dry.
3. With a clean rayon mop apply thin, even coats of Green Finish.
4. Under normal conditions, allow to dry for 30 minutes between coats.
5. For best results, apply a maximum of 4 coats in 24 hours.
6. Allow 48 hours for the finish to reach full cure before wet cleaning. Burnishing will speed cure time.

Maintenance:
Daily:

1. Sweep or dust mop frequently to remove gritty soil.
2. Use our Green Clean (#8513) to damp mop spills as they occur. Damp mop or auto-scrub nightly with Green Clean.
3. Buff if desired with high speed equipment and blended hair pads.

Weekly:

1. To repair and deep clean floor, apply Green Restore (#8549) with mop or auto-scrubber.
2. Allow floor to dry.
3. Burnish floor with high speed equipment. This finish also responds to spray buffing with conventional speed equipment. Note: Always dust mop after burnishing or spray buffing.

Periodic Recoating:

1. Dust mop entire floor then scrub aggressively using Green Restore and auto-scrubber with a red or green pad.
2. Rinse floor and allow to dry.
3. Apply Green Finish.

** See label directions and MSDS for complete usage and safety instructions.

Application Hints

1. Green Finish is very easy to apply with a standard finish mop and dries perfectly clear.
2. For best results in high traffic locations (such as supermarkets) and entranceways, apply four coats the first night, then follow-up a few days later with four more coats. This gives you the desired film thickness from which to properly maintain your floor.
3. Allow 48 hours for the finish to reach full cure before cleaning. Burnishing will speed cure time.
4. If product freezes, do not use.

Pad Recommendations *

Packaging Specifications

Package	Sizes Available	UPC Codes	Pack Size (inches)	Cube (ft.)	Pack Wt. (Lbs.)	Full Pallet
	5 Gallon Pail	783366820153	12 x 14	1.17	45.73	36
	4 x One Gallon	783366820146	13 x 13.5 x 12.5	1.27	36.16	36