Speed Stripper

Product Lines | Equipment | Product Systems | Technical Help

Training Aids | Sales Support

Speed Stripper
Labor-Saving Finish Remover (2888FX)

Features | Properties | General Directions | FAQ

Packaging Specifications | MSDS

Features

Leaves no alkaline residue behind simplifying rinsing and eliminating recoat problems.
Removes heavily burnished acrylics and urethane-fortified acrylics.
Use for wet or dry surface stripping prior to recoating.
Fast evaporating, mild pH formula is ideal for stripping sensitive floors such as rubber and linoleum.

Properties*

* Properties are typical and subject to usual manufacturing tolerances.

General Directions**

READ BEFORE USING:

This is a highly aggressive formula. Read precautions below.
To achieve best performance, experiment in small test area with various dilutions before applying generally.
Dilute before using. Do not use on painted surfaces or wooden floors. Use cautiously for stripping linoleum, rubber or asphalt tile as stripper may cause bleaching, softening or bleeding.
Wipe up any spills or splashing from baseboards or painted surfaces immediately.

DIRECTIONS:

To remove heavy build-up, dilute with warm water as follows:
1 part stripper to 4 parts water.
Apply liberally to floor covering 100 square feet at a time. Be sure to leave surface VERY wet!
Allow to remain on floor 5 to 10 minutes. Agitate for 100% removal of old floor finish.
Pick up solution using a wet vac or auto-scrubber. If any finish remains (around baseboards), reapply stripping solution and agitate as necessary.
Rinse floor thoroughly. Allow floor to dry.
Apply finish or seal.

NOTE: For stripping and maintaining asbestos containing tile, follow OSHA guidelines or EPA guidelines.

** See label directions and MSDS for complete usage and safety instructions.

Packaging Specifications