High Build™
Ultra High Solids Finish (285FF)

Features | Properties | General Directions

Application Hints | Pad Recommendations | FAQ

Packaging Specifications | MSDS

Features

• All purpose, all system ultra high solids finish.
• Labor-saving 29% formula offers greater protection with fewer coats. Three coats provides the same protection and appearance level as five to six coats of standard finish.
• Urethane-fortified for toughness and long-term durability.
• User-friendly application - use a finish mop to apply - no special applicator is required.
• Very fast drying - 30 minutes under normal conditions.
  

Properties*

• Type - Acrylic/Urethane Emulsion
• Form - Opaque Liquid
• Odor - Bland
• Color - Milky White
• Weight Per Gallon - 8.65 Lbs.
• pH - 7.5 - 8.5
• Floor Solids - 29%
• Coverage - Up to 3,000 Sq. Ft. Per Gallon (75 m² per liter)
• Dry Time - 30 Minutes
• Slip-Resistance - UL Classified
• V.O.C. Content - < 200 gm/l

* Properties are typical and subject to usual manufacturing tolerances.

General Directions**

Application:

1. Strip floors to remove old waxes, sealers and finishes.
2. Rinse thoroughly and let dry.
3. With clean rayon mop apply thin, even coats of High Build.
4. Under normal conditions, allow to dry for 30 minutes between coats.
5. For best results, apply a maximum of 2-3 coats in 24 hours.

Maintenance:

1. Daily: Sweep or dust mop as necessary to remove gritty soil.
2. Dirty Floors: Clean with 2-4 oz. of Nu-Tral Cleaner (#507) per gallon of water. Rinse and let dry.
3. Traffic Area: Clean with 2-4 oz. of Nu-Tral Cleaner per gallon of water. Rinse and let dry. Apply additional thin coats of floor finish to traffic lanes as needed.
4. Buffing: If desired, periodic burnishing with soft ultra high speed pads will enhance appearance.
5. Periodic Complete Maintenance: Ordinarily, stripping is not required more than (1) or (2) times per year. Use up to 32 ozs. of our stripper per gallon of water.

** See label directions and MSDS for complete usage and safety instructions.

Application Hints

1. High Build is easy to apply with a standard finish mop and dries perfectly clear.
2. For best results on stripped floors, apply three coats the first night, then follow-up a few days later with three more coats. This gives you the desired film thickness from which to properly maintain your floor.

Pad Recommendations *

NOTE: A soft, white pad may be your best pad choice for a week or two after applying finish. Once full cure is achieved, pads shown on chart may be used.

* These are generalized classifications based on market research. Terms and definitions may be different from manufacturer to manufacturer; however, the above information will help to determine pad compatibility with various floor machines and Essential finishes on the market.

Packaging Specifications

Package	Sizes Available	UPC Codes	Pack Size (inches)	Cube (ft.)	Pack Wt. (Lbs.)	Full Pallet
	55 Gallon Drum	7833662285006	23 x 34	10.41	496.63	4
	5 Gallon Pail	783366285051	12 x 14	1.17	46.33	36
	4 x One Gallon	783366285044	13 x 13.5 x 12.5	1.27	36.64	36